Multitronix
  • Home
  • Products
    • Kate-3 Transmitter
    • Kate-3 Pyro Board
    • Kate-1 Transmitter
    • Receiver
    • Turn-on Coil
    • Carrying Case
    • Nosecones
    • Specifications
  • Buy
  • Software
  • Firmware
  • Documents
    • Kate-3 Documents
    • Kate-2 Documents
    • Kate-1 Documents
  • Flights
    • 408K Flight
    • 293K Flight
    • 188K Flight
    • 142K Flight
    • 118K Flight
    • 96K Flight
    • 90K Flight
    • 40K Flight
    • 28K Flight
    • 16K Flight
  • About
  • Contact
Picture
Mx230 Option-25 Battery Board

The battery board is the same size and has the same mounting hole pattern as the existing Mx230 Option-20 outrigger board. The battery board mounts on standoffs from all six mounting holes on the outrigger board and is positioned right over the top of the transmitter.  After installing the battery board onto the transmitter, everything still fits nicely into a 3" diameter coupler tube.

The six mounting holes can also be used to mount it a custom sled. Depending on your sled thickness, it might be necessary to replace the 4-40 mounting screws with longer ones.

The transmitter power button is accessed through a hole in the battery board.  A small dowel or other tool is needed to press the power button.  It cannot be pressed by finger.   

The pyro battery can be a standard 9V as shown here or a LiPo battery. 


Light pipes allow all the LED indicators on the transmitter board to be clearly viewed.  

A cut out in the battery board allows access to the USB connector.
Picture
Mx230 Option-20 transmitter shown along side the battery board that mounts on top of it.

Picture
Download
Installing the Mx230 Option-25 Kate-3 Battery Board
Rev 1.0,  June 1, 2021
Picture
Download
Removing the Mx230 Option-25 Kate-3 Battery Board
Rev 1.0,  June 1, 2021

Mx230 Option-25
This is a short HD video (47 seconds) that shows a 360 degree view of the battery board mounted to the Kate-3 transmitter and pyro board.  Be sure to expand it out to full screen to get a good look at the entire package.  (There is no sound.)

Picture
This document shows some of the features of the battery board.
mx152_opt25_batteryplatform.pdf
File Size: 55 kb
File Type: pdf
Download File


Picture
TelemetryPro... "when failure is not an option"

TelemetryPro® is a registered trademark of Multitronix LLC

Multitronix LLC reserves the right to change or obsolete products without prior notice.

Website copyright © 2014-2023
Multitronix LLC       All Rights Reserved